LG LT800P Refrigerator Water Filter, ADQ73613401

✔ Free Shipping

✔ No cost 30-days Return

LG LT800P Refrigerator Filter.
This filter is easy to install and offers 6 months or 200 gallons of filtered ice and water.
It reduces contaminants like rust, cysts, lead, mercury, dirt, silt, sand, limescale, and other impurities, leaving you with crisp, clean water.
The LG LT800P ADQ73613401 is the correct replacement for Kenmore 9490, Kenmore 46-9490 and Kenmore 469490 models.

Specifications:

Brand: LG
Part Number: LT800P, ADQ73613401
Pack Size: 1
Filter Life (Months): 6
Filter Life (Gallons): 200
Dimensions: 1.8" x 1.8" x 7"

How do you install the LG LT800P?

INSTALLING THE LG LT800P - BESIDE DOOR
1.Lift-up and remove the lower door bin. Swing the right end of the old LT800P out of the compartment and then grasp and rotate the water filter counter-clockwise to remove it from the filter head.
2.Take a new LG LT800P water filter out of its packaging and remove the protective cover from the o-rings. Insert the new LT800P filter into the filter head and rotate it clockwise until the arrow on the new filter lines up with the arrow on the filter head. Swing the filter back into the compartment.
3.Put the lower door bin back to its original position. Now that the LT800P is replaced, dispense 2.5 gallons of water to remove trapped air and contaminants from the system. Depress and release the dispenser pad for cycles of 30 seconds ON and 60 seconds OFF, rather than dispensing continuously.
4.Replace the water filter when the replace filter icon turns on. After replacing the water filter, press and hold the Water Filter button for three seconds to turn the icon light off.

INSTALLING THE LG LT800P - ROOF TOP
1.If the top shelf, which is located below the water filter, is in the highest position, it will need to be removed.
2.Pull the old LT800P water filter downward and turn it counter-clockwise to pull it out. Make sure to rotate the filter down completely before pulling it out of the manifold hole.
3.Take a new LG LT800P out of its packaging and remove the protective cover from the o-rings. With the filter tabs in the horizontal position, push the new filter into the manifold hole, rotate it up into place and close the cover.
4.Put the lower door bin back to its original position. Now that the LT800P filter is replaced, dispense 2.5 gallons of water to remove trapped air and contaminants from the system. Depress and release the dispenser pad for cycles of 30 seconds ON and 60 seconds OFF, rather than dispensing continuously.
5.Replace the water filter when the replace filter icon turns on. After replacing the water filter, press and hold the Water Filter button for three seconds to turn the icon light off.